All about how to paint a pimp radio control cars

Dec 27
10:04

2011

Soo Yeon Jung

Soo Yeon Jung

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

You can master steps to paint and pimp your radio control cars.

mediaimage

Automotive paint is a painting very easy to implement but it has its requirements,All about how to paint a pimp radio control cars Articles such as surface finish must be perfect to paint radio control cars without any irregularity. Opt for the top brands on the market. Some people do not know, which the bests are but what if it is that they give excellent results in our precious painted rc model.

Of course we will use these radio control cars paintings in quality since these paintings as stated above are expensive because it is professional automotive paints

Starting with pre-painted procedures

The application is very easy. The rig you must use on surfaces are only type fiberglass, or plastic after a slight airframe sanding mainly prior to final painting and used to leave a good finish on the paint surface and to get a good grip on this, since as said, the paint we use is very demanding in terms of final finishing of the surface that we paint, we need to leave an area as regular as possible.

The engine area comes finished gel-coat, this is the majority, this being a sort of primer on mold, if completion is good gear need not apply. However in many cases in certain areas is convenient to apply rig mold defects or misapplication of the gel-coat. The rig is easily adapted for sanding water and therefore we must not give in porous materials such wood, etc. especially, since it is imperative to use the liquid element, therefore we will use it only in impermeable surfaces such as fiberglass, plastic, etc. In any case we will give a thin layer of this product, so that the weight remains impeccable. Do not panic, you can easily learn how to leave your radio control cars fabulous.

This rig can be used with sprays, guns, etc or even with a simple spray and compressed air. If anything, you can do your own compressor. The rig I use is two parts and we must use acrylic hardener and solvent, all these products should be those recommended by the manufacturer and mixed in the correct proportion.

If you have doubts, make sure you remove them before you begin. Most radio control cars are delicate. Thus, they deserve proper care. Paint the cars properly. Ask for assistance and get rid of concerns. You must begin with comfort. Find sources that include the features and products recommended for rigging gray remain the same for white.