A guide to take care of rc helicopters

Jan 6
09:35

2012

Kim Hyo Yeon

Kim Hyo Yeon

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

Given the well-carbureted rc helicopters engine, it may behave strangely (fast motor, etc) if so, stop the engine and check the status of the fuel lines.

mediaimage

You can always ensure the right rc helicopters performance. If the trim of the station did not get the settings,A guide to take care of rc helicopters Articles you have to remove the linkage and adjust.

Tips

Follow basic tips that will lead to top trim and engine results:

·         When adjusting the linkage and see that the barrel of the carburetor does work correctly you must check if the car stops, if it is so must be adjusted by pressing the pads of the disc (that the rc heli monitors the braking time) or simply by pressing the linkage.

·         There are sometimes you have to use a more powerful servo for gas / brake and servo that sometimes the "standard" loses force when braking, with a servo 6 kilos in the gas / brake you will have the enough strength to brake. To address if you change too quickly earn one of more weight.

If we see that the rc helicopters are not balanced then the station will trim the butt. Thus we put the steering trim placement in half and remove the servo horn and place it so that the wheels are straight. Discover how to make the best out of a basic model.

Maintenance

After filming, we must take into account the need to make a brief rc helicopters maintenance. Remove the air filter and clean it, for them to remove and clean sponge until clean, let it dry and made air filter oil, and that covers all the foam in general. When doing the trick for the bag, we put in the sponge and we take oil and drain well in.

Try to find the best oil and cleaners. Failure to do so, may damage your model. Make wise choices to avoid future mistakes.  It's good sometimes to have two sets of filter because while cleaning one gets the other. The top techniques are available for you to become an expert.

Silicones

Periodically reviewing the differential is good. Make silicone spreads as it helps to prevent spoiling the parts. Every month or every two months you should fill them with densities between 7000 and 10,000. When you notice a clank in the spreads, do not waste time. You may do the same with other rc helicopters parts. You can make it happen. Find out what will suit your model best. Take care of your rc heli so you can then sell it or pimp it better. Prices vary so do not panic.