A lot to learn about rc car key points

There are many important rc car matters.  To begin, start your approach in a simple way. You can ensure a consistent riding time with a trainer type car. Usually, this type of model is amazing. This session, will result in a model easy to maneuver with- fun and safe!

You can learn how to clean your model, too. For instance, the wood surface should be sealed using filler. Polyester resins must be cured at least 72 hours before painting. All surfaces will benefit from the use of a quality pain. The best paint is designed to be used only with the best product line and may not be compatible with other paintings or prints.

Important: Always apply the cleaning formula at room temperature (21 ° C) or more. Always tests the compatibility of the paint prior to painting the entire surface. Always paint in well ventilated areas.

For best results, follow these steps:

- Use masking tape of good quality vinyl, protecting all rc car areas that do not want to paint. Protect all the elements in the environment where you go to paint.

- Clean the surface thoroughly using alcohol or a degreaser. For best results, use the Tack Cloth (tack cloth) to remove dust and lint and get an absolutely clean surface.

- Shake the spray at least 1 full minute before applying. Stir every 5 minutes for the duration of the spraying process.

Keeping the spray at a distance of 30 cm. the surface, eat paint the rc car model using soft hands and long, overlapping each hand about half the width of each hand. The surface must be covered with three or four hands light but couples. Between coats let stand 2 to 3 minutes. Do not wait to dry between coats of the same color.

Finally apply a slightly more charged last hand, enough to make the surface look wet. Remember, use as little paint as possible to complete the work, a lot of paint is a lot of weight.

- Let the solution dry for about 20 minutes, and the paint will be impervious to the fuel (nitro methane maximo15%) after 24 hours. After those 24 hours the rc car can be masked for additional colors. After use, invert the aerosol valve and press for 1-2 seconds to clear the valve. The model becomes a paintable surface in 24 hours. For best performance against the fuel let curing approximately 48 hours. Climates with high humidity can lengthen the curing processes.