In order to protect the beautiful skin you must pay special attention to the method of washing face. And please try to compare your hairdressing procedures.
Are you always scrubbing your hair with shampoo hardly? In order to protect the beautiful skin you must pay special attention to the method of washing face. And please try to compare your hairdressing procedures.
1. First of all, before using the shampoo, flush your hair with warm water first, let the hair and the scalp get fully moisten, let the dirt and hair dose dissolved in water, to make the hair easier to clean.
2. Pour the shampoo on the hand, and add some warm water then rub to create rich foam. The first pass, to massage gently, the second pass, to massage the all hair root and scalp with finger belly, after all rubbed up then to wash clean.
3. Pour the hairconditioner in the palm, then to spread on the hair evenly. And opposite to the shampoo usage, to massage began with hair tip clamped hair with finger gently and evenly, and then daub to the whole hair slowly. Don't flush immediately after massage, you will get double result with half the work.
4. Wipe the hair to a half dry state, then to wrap the hair with a dry towel, compress the towel tightly hands with your hands, to absorb the redundant water on hair clean. Hair on the wet condition, the hair squama is easy to fall off, so don't use the towel rub hair hard, in order to avoid causing the hair squama damage of the hair surface.
5. If you use the blower improperly can lead to the hair damaged, so choose the correct usage is particularly important. The idea better than using hot wind to evaporate the moisture is: Take advantage of the wind that produced by the blower to make the hair fully contact With air when you comb your hair with hands, and the redundant moisture on the hair surface would be evaporated by the wind, You should start from the hair root to blow, and finally to blow dry the hair tip.
How to Change the Sway bar bushing and sway bar endlink on new beetle (1)
The sway bar (sometimes called anti roll bar) connects the left and right suspension to the front subframe. There are bushings on the middle and ends (end links). Your VW TDI only has a sway bar in the front, there is no sway bar in the rear because it's a torsion beam suspension.
How to Change the Sway Bar Bushing and Sway Bar Endlink on New Beetle (2)
Raise the front end of the car, chock the rear wheels, remove the front wheels, rest the car on jack stands, and make sure the car is safe and secure before getting underneath at all, see the TOS Agreement for the legal disclaimer.
The Working Principle of Independent Front Suspension (4)
Overall, with the vast plethora of Mustang II-style IFS kits ranging from basic budget setups to fully polished showpieces on the market today, there is very little reason to go with a used Camaro front clip.
