It Is Necessary for You to Clean Your Skateboard Sport Shoes

It is likely for skateboard shoes to become dirty, because the canvas material is widely used. We can use water to remove ordinary dirt. Yellow rusts, however, are tend to appear on shoe uppers where are close to shoe holes after using water to wash. The reason is that the color of metal shoe holes will fade off. If you want to solve such a kind of problem, it is also very easy. Before wearing or washing, you can paint transparent nail polish on shoe holes. Through doing this, it not only can prevent metal oxidation, but also can make your shoes keep new for a long time.

You can gently brush the dirty shoes through using the compound of water and detergent, and followed by washing with neat water. In order to make it dry, you should put it into a cool place, where can not be directly exposed by the sunlight. For the sake of getting away from aging, gluing, color fading as well as severe deformation, do not open central heating or flame. However, the working life of shoes will be lessened with some improper nursing cares, such as too much direct sunlight and heat blowers' heat. It will not be right to make a long soak when they are washed and brushed. In general cases, the immersion time shall not be more than twenty minutes.

If you want to have a long term storage, you should cleanly wash and brush the shoes first. They should be placed in a cool position with ventilation after they are in dry condition. In this way, there will be sufficient time for them to be dried, so as to avoid mildew. In order to avoid serious deformation of shoes with genuine leather, it would be best for you to fill the inside shoes with paper balls or shoes support so as to hold up them. Put the shoe-heads downwards, make the soles toward the wall, and allow them to dry in ventilated place under normal temperature.

There are different ways for different materials. A bit collar net can be used if shoes' outsoles and shoe sides' materials are not nylon. After ten or so seconds, you can carry a soft toothbrush to wash and brush gently. But the brush time should not be too long. For the sake of washing away the bubble, warm water or cold water ought to be applied after you wash brush it. You should try to minimize the time that chemicals erode to your shoes.

After cleaning it, you should immediately use a dry rag to wipe cleanly the residual water. If the shoes you wash have visible cushions, you should firstly wipe cleanly the water around cushions when the above processes are finished. Supposing there is possibility, and then in order to pick out the stones that are kept in outsoles' grains during the procedure of walking, toothpicks can be applied. The reason is that lines of outsoles will appear deformation if outsoles' lines are mingled with unusual substances for a long time. To some extent, it will affect the braking performance of shoes. The cleaning methods will rest with the primary materials composition of your vamps.