Method of Filling up Lock Holes in the Wooden Doors

In many houses we have noticed the appearance of the small holes inside the wooden doors. These holes are actually the locks that have been filled by the person. The procedure for filling up the door locks is mostly carried out by the trainer and expert but when the person tries to be the expert itself then the outcome would certainly be the damaging of the wooden door. If you really want to tackle the problem with self help then it is vital that the person must know some of the beneficial guidelines that are involved in the filling stages. In this article we are carrying out the jam packed details of the method that would be used for the filling up the lock holes. Firstly before starting the process you must have to get hold over some ingredients adding with the measurement tape, scrap wood, hole blade, wood glue, electric drill, wood filler, paint brush and sand paper.

In the first level just take the measurements of the hole and length of the door through the tape. Now just cut the wooden hole blade that is exactly the same size of the wooden hole and also fit the drill machine along with the hole blade. Just place the hole blade with the help of the wooden glue. When you apply the wooden glue just make sure that you didn’t carry out any other step until it didn’t get dry. Now when the glue gets properly dry just apply the filer inside the lock. Also allow the filler to get dry for few minutes. After it gets dry just take the sandpaper and the paint the hole lock area of giving it the previous finishing touch. Additionally for filling the lock plate you have to once again measure the diameter of the hole with the help of the measuring tape. Then take the filler plate that is equal to the wooden hole lock size.

Now just place the plate at one side of the door and place the other side on the opposite side of the door. After placing the plate just press it tightly until you didn’t receive some voice. Now all the bolts and nuts of the lock that were unlocked in the beginning just reinstall them once again. Make sure that all the nuts are placed on their right place and are equal in quantity as well. When you feel that all the solutions and paints on the hole has get dry fully then go for the finishing touch of the reinstallation of the nuts otherwise the whole method would be useless. Well at the end we would figure out that these steps are much effortless and can be carried out by any ordinary person after one single try. However, this method just demands for the proper attention and concentration and we are sure that the person would certainly get succeeded in filling the lock hole of the wooden door. So just rush to the wooden doors now and try this method.