Remove Mistakes And Save Your Company Time And Money

You will find a few time wasters greater in price and effort than errors. Errors waste more then additional time; they waste material, effort and funds. The material, based on what is employed inside the component can range from just a couple of cents worth of aluminum to large amounts of a precious metal that will need to be reused in some other capacity or melted down and started all over again.

Even if the material can be used again, the amount of time and energy used to make it reusable is just rolled back into the cost of the product. Every time there is a mistake, the price to produce the part rises. Sometimes the part that was made wrong can't be reused and the entire part has to be made out of new material. This type of waste is very costly.

So you not merely waste the material, but the time required to create the part initially and any time lost to quit the procedure and call back the incorrect parts. Just how much time was wasted working with the wrong parts? Did any of the bad parts make it to the end user? How will your buyers react knowing that the poor parts ended up in their hands and into their merchandise? How will you rebuild that trust and relationship? Immediately after the losses in material, and the loss of time, this is even a bigger lossl and even harder to make up.

Everyone knows that labor may be the most costly part of any method and after you lose time and pay for labor that does not add any value in production; it is an even bigger loss. It's quite hard to make up for a mistake like this and it's bad enough if one part makes it through that is poor, but this is exactly why the process must stop then and there. No corporation can afford a whole run of bad parts, which is why it is crucial to have some sort of safety net in place having a very good top quality control program.

Errors are going to happen, it really is a component of life and component of doing business, but limiting the errors and keeping their ramifications to a minimum is the most vital thing to do. If there is a mistake on the line, in production, it needs to be limited to only one mistake after which it must be fixed. If there is more than one mistake, then you have a more significant issue.