We Will Help You Wash and Brush Skateboard Shoes

It is likely for skateboard shoes to become dirty, because the canvas material is widely used. We can use water to remove ordinary dirt. Yellow rusts, however, are tend to appear on shoe uppers where are close to shoe holes after using water to wash. This is due to the color fading of metal shoe holes. It is very simple to solve this matter as well. Before wearing or washing, you can paint transparent nail polish on shoe holes. Through doing this, it not only can prevent metal oxidation, but also can make your shoes keep new for a long time.

When your shoes are dirty, it will be available for you to brush gently with water and a little detergent, and then rinse with clean water again. In order to make it dry, you should put it into a cool place, where can not be directly exposed by the sunlight. Never use heating installation or direct fire to dry it so as to avoid aging, gluing, color fading and severely deforming. However, the working life of shoes will be lessened with some improper nursing cares, such as too much direct sunlight and heat blowers' heat. When you wash and brush them, you can not soak them in water for a too long time. Under normal circumstances, the soak time should be less than twenty minutes.

If you want to have a long term storage, you should cleanly wash and brush the shoes first. When they are dry, put them in a cool and ventilated place. In order to avoid mildew, enough time must be provided for the shoes to dry. In order to avoid serious deformation of shoes with genuine leather, it would be best for you to fill the inside shoes with paper balls or shoes support so as to hold up them. In order to make your shoes dry in ventilated place at common temperature, you should make your shoe-heads upside down and make your soles to be the opposite direction to the wall.

There are different ways for different materials. A bit collar net can be used if shoes' outsoles and shoe sides' materials are not nylon. After ten or so seconds, you can carry a soft toothbrush to wash and brush gently. But the brush time should not be too long. For the sake of washing away the bubble, warm water or cold water ought to be applied after you wash brush it. In this way, the erosion time that chemicals maybe put to your shoes can be tried to be reduced.

You ought to, at once, neatly wipe the residual water with a dry rag after you wash it. If the shoes you wash have visible cushions, you should firstly wipe cleanly the water around cushions when the above processes are finished. Supposing there is possibility, and then in order to pick out the stones that are kept in outsoles' grains during the procedure of walking, toothpicks can be applied. Because if grains of outsoles filled with other subjects for a long time, they will be deformed. Shoes' braking performance, to a certain degree, is going to be influenced by this. The cleaning methods will rest with the primary materials composition of your vamps.