Cisco CCNA, CCNP, and CCENT Questions: SDM, Lily Pad Networks, and More!

Sep 12
06:24

2008

Chris Bryant

Chris Bryant

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

In today's Cisco certification practice exam question set, we're testing your knowledge of configuration modes, SDM, lily pad networks, and more - so let's get started!

mediaimage

In today's Cisco certification practice exam question set,Cisco CCNA, CCNP, and CCENT Questions:  SDM, Lily Pad Networks, and More! Articles we're testing your knowledge of configuration modes, SDM, lily pad networks, and more - so let's get started!

CCNA Certification And CCENT Certification:

What keystroke will get you out of the following configuration mode? Will your changes be saved by this keystroke?

Would you like to enter basic management setup? [yes/no]:y

Configuring global parameters:

Enter host name [Switch]: Switch1

The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration.

Enter enable secret:

CCNA Security Certification / CCNP ISCW Exam:

Two popular signature actions in SDM are denyAttackerInline and denyFlowInline. There's a subtle difference between the two. What is it?

CCNA Wireless:

What is a "lily pad network"?

CCNA Voice:

You've configured RTP Header Compression (cRTP). To what degree will the 40-byte IP/RTP/UDP headers be compressed if UDP checksums are in use?

CCNP Certification / BSCI Exam:

What is the default seed metric of an EIGRP route that is redistributed into an OSPF process?

CCNP Certification / BCMSN Exam:

What global command resulted in the following output?

%Warning: this command enables portfast by default on all interfaces. You should now disable portfast explicitly on switched ports leading to hubs, switches and bridges as they may create temporary bridging loops.

CCNP / ONT Exam:

The following is the (very) partial output of what command?

R1# ?

Serial0/1/0

AutoQoS Discovery enabled for applications

Discovery up time: 4 minutes, 29 seconds

AutoQoS Class information: Class Voice:

Recommended Minimum Bandwidth: 43 Kbps/5% (PeakRate)

Here are the answers to today's questions!

CCNA / CCENT Answer: That's the dreaded setup mode, and you can exit that mode without saving your changes with the ctrl-c keystroke.

CCNA Security / ISCW Exam Answer: denyAttackerInline denies the source IP address of the offending packets entirely. This action is carried out by the dynamic creation of an ACL that blocks that particular source IP address. denyFlowInline blocks the specific offending TCP flow, but still allows other connections from that particular source.

CCNA Wireless Answer: It's a wireless network consisting of multiple Wireless Access Points (WAPs), with each connected to a different network - this topology allows roaming users to access their network

CCNA Voice Answer: If UDP checksums are in use, the headers are compressed to 4 bytes.

CCNP / BSCI Answer: OSPF has a default seed metric of 20 for any route learned via redistribution, not just EIGRP routes.

CCNP BCMSN Answer: The description is great, but the command's syntax is just a bit clumsy - it's spanning portfast default.

CCNP ONT Answer: show auto discovery qos.

Visit my website for more than 200 free Cisco certification exam practice exams, fully-illustrated tutorials, and more!