How To Repair Your HP G60 Screen LCD Screen Effectively

Jun 2
09:18

2011

Rosie Martin

Rosie Martin

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

Wonderful Tips: More information on Laptop Accessories & LCD Screen Panel, please visit www.hootoo.com

mediaimage

As the most important output device,How To Repair Your HP G60 Screen LCD Screen Effectively Articles whether desktop or notebook computer, monitor fail to work, it mean you can not do anything. In the case of the black screen, blinking, fuzzy and other common faults, here listed are some solutions, which help you sovlve such problem easily.

1, the blank screen

As most of us know, the blank screen is the most common faults, including the tips of no signal that are also belong to blank screen areas. Generally speaking, the reasons that caused the blank screen have two cases: be electrified or not.

Normally, if the display light is off which show HP Pavilion G60 LCD Screen does not electrify, in this case, first of all we should observe whether the host and the power is plugged in, the host fan spins, hard disk light and keyboard light is flashing, to determine the host is electrified. If the host is normal, the cause of the malfunction mostly lie in the display screen. At this time, we can check whether the card and the monitor signal cable are in good condition, and the graphics card installed properly.

If everything goes well, and the display light is on, then it must be the input problem. As we all know, there are VGA and DVI port, the two interfaces in display screen, and some is with HDMI, AV and other interfaces. In general, most monitors are interfaces adaptive input, comparing to 463958-001 ac adapter. In short, where a signal is indicate which. But not all monitor are adaptive display. For those who do not display adaptive input, we will adjust by ourselves. If the problem still exsits, then basically it can be concluded that it must be the problem of the display hardware.

2, the fog screen

In fact, most of us are quite familiar with the fog screen, especially for the CTR monitor. When the room humidity is high, you will find the screen with a fog. In this case, you can rub its surface, but the worst part is the inside of LCD screen. As we all know, what LCD screen fear most is water. And the best way to solve that is to use the lamp drying slowly. If the heavy mist have hurt the computer components, you must send it to the repair store.