Find the top rc cars connection systems

Jan 9
08:58

2012

Meng Lee

Meng Lee

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

The theory says that there should be no problem in connecting two rc cars equipment in this configuration, only to be met with some electronic adjustments related to the type of signal that is sent and the levels of tension between them, we must also take account of adjustments and adaptations protocol cable connector physically connecting the radios.

mediaimage

There are many rc cars connection solutions. The good news is that the protocol used is standard PPM,Find the top rc cars connection systems Articles some have some differences, but are double. The command works by connecting two computers, one of them called professors and other students (see figure below). There are different ways or methods of connecting to each other, which we will see below, but basically always about to send the position of joysticks on the plane to be controlled from the student or teacher, at the discretion of the person driving the Teacher team.

Connection between two teams

The cable that connects rc cars teams makes them work so that one can be used by an apprentice or student safely. The team of the teacher has a command that enables or not the student's intervention and thus will be able to regain control when desired. Also the teacher is the only team that is transmitting high frequency signal or radio at the same rate of transmission that the receiver is in the plane. The student equipment should not even raise the antenna transmission. A good system means that when a team is in student mode, you cut power to the internal radio module does not transfer at that time because it can cause serious interference.

There are systems that do not work with the rc cars equipment recently described, which are: All old equipment that Multiplex are made before the series MC (MC3010, MC3030 and MC4000) even before the series Cockpit.

 

These old radios are interconnected in two commands only with a cable that ran the battery power of the teacher and student, in a word; the teacher turned off or turned on your radio or your student will. Both rc cars radios had to be equipped with the same set of crystal receiver with the transmitter on and with the antenna extended.

Typical methods of double command

The modern rc cars transmitters can be prepared to work in the following way, which is by the ones we can find when wanting to connect two radios in two commands. The computer receives the signal Teacher Student PPM and it is manipulated to add the same original information that the teacher has set.

The radius of the teacher has the ability to selectively release the Student some rc cars channels, but in this case, unlike the former, the student must have full capacity to control all functions of the model to control.