Radio control cars considerations and top ratio facts

Fitting your radio control cars course will only affect how the radio emission, the other functions, mixtures, memories, etc work. Generally speaking the schedule is not affected by the modification, i.e. just have a programmable radio before but now with the new technique implemented.

To continue using your old radio receivers will need to purchase a broadcast module 35 MHz that you will connect your modified radio control cars radio, in fact you will become your station in modular with the exception that you will have to remove the back cover to change the module. By removing the back cover of your station are in the foreground on the antenna printed circuit board, this board is the RF phase of your station, you will definitely remove but you must be youll marked and located the wires that bind the rest of the radio.

There are two sets of cables, emission and trainer connector latter are not necessary for your purpose but as you lose the square connector that is integral with the plate that you will withdraw, if you want to enable a proper solution that will see at the end.

Encoder Cables are part of the procedure. Remember that signals travels and you must get to know about the antenna connectivity, too. Look for a printed circuit of Futaba 6 EXA cables, which are labeled on the surface, but beware, you have to unsolder label before if you do not want to miss the reference. The circuit uses a T7 Futaba more carefully, the antenna connector can be unplugged but the others are fixed to the circuit, the encoder is also labeled on EXA but no trainer cables, so that you must follow the indications of the drawing. Knowing the connection of these cables in the emission module is easy to make a connector that takes each driver to the destination. You must get to know circuit aspects about radio control cars. Remain patient! This is the only way to fully understand what this is about.

The Futaba modules to connect as you see the picture, the central pin is used to inform the station that is occurring and you turn on the issue to type a message in the display, this assembly is not usable for anything. You will be able to opt for other solutions, too. Stick to your decision of enhancing overall radio control cars functionality.