Rc helicopter- Buy a sturdy model

When buying an rc helicopter, you must consider a few aspects. For instance, you might as well check the operation of the gyro switch on the radio and try not to move the helicopter a few minutes then turn his hand to the side and observe the response of the gyroscope. If this turns the tail servo you should not to worry because the gyros have to invest a small switch operation. Options are limitless. Once you get used to this technology, everything will go smooth. Get prepared to venture onto a grandiose rc world.

Begin by ensuring top attachments. For instance, to adjust the rc helicopter. gyro first observe the movement of the tail servo arm to accelerate a bit and turn the radio tail to the left and right. Suppose that if the tail servo arm rotates the helicopter clockwise turn right. Then with the engine off if you turn the helicopter in a counter-clockwise (the helicopter would rotate to the left) the servo arm should be in the direction of clockwise rotation to compensate. If the move was contrary reverse the operation of the turn.

Once you have fully installed the rc helicopter parts, proceed as follows first we will check if it acts in the right direction, adjust by turning the screw (if the sensitivity is adjusted by a potentiometer) the sensitivity to maximum or from the issuer (other gyros can be regulated through a channel additional station). If the gyro acts in one desired when trying to accelerate to take off rather than counteract torque will do the opposite by turning quickly on the helicopter itself. Once done, proceed by bringing the sensitivity of the half turn. This is not so hard! Then proceed to make takeoffs and go up the sensitivity to a point where the tail starts to oscillate. From that point we reduce the rc helicopter sensitivity to the tail is again stable. This is important because we need to fly with the highest sensitivity possible.

If anything, you can find a solution to any obstacle, since these devices are high-tech. Keep some double-sided tape with foam handy, this is thick enough to isolate it from vibrations that can also interfere with its operation and reduce its life. One of the cables go to channel 4 receptor and the other will be connected to the tail servo. We turn the adjustment screw in the middle of the gyroscope to reduce its sensitivity to start. In short, installation of gyroscopes is easy. You have no excuse not to get the best rc helicopter now!