Controlling waveforms and rc helicopters circuits

Jan 9
08:58

2012

LiuJiajia

LiuJiajia

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

When experiencing any issue in rc helicopters circuit, a solution is to see the signal with an oscilloscope, but like most fans cannot buy an expensive so they are there to find an alternative.

mediaimage

The rc helicopters circuits waveform is a bit that is every 20 to 30ms (not important while in those days),Controlling waveforms and rc helicopters circuits Articles which varies from 1ms to 2ms. These simple specifications which are intended to reach from the design of the encoder for each channel that aims to control.

Position of a servo PWM signal over

One of the easiest electronic rc helicopters circuit to start is to make a PWM generator with LM555 which is used to check the status of devices connected to the output of the decoder.

Take a look at any PC and take note, you will surely find more or less the following components: processor, memory, a few circuits that do not know but you know that are needed, the system ports for connecting keyboards, monitors, and mice among external memories other peripherals, power supply and other things.

In this review we have made of a PC, we can observe a complete computer system, used to do a lot of different things, depending on an item you do not see, but we know it is essential to the work of these physical devices: the software. We are quite accustomed to dealing with the PC, but do not imagine that many of the new technological gadgets with which we even wonder, and others as common as the TV remote control or mouse, carry in their within a system very similar to the same PC.

We speak of a complete computer, put into a pill or integrated circuit. Although it seems preposterous, indeed, a microcontroller is just a complete computer with processor, memory, input / output (I / S) and peripherals, all encapsulated or embedded within an integrated circuit. Computer on a chip is precisely the way that Intel first brought to market in 1976 microcontroller. The same applies to rc helicopters micro controllers.

Of course, with a microcontroller you cannot do the same things with a PC, but it does not matter, because the microcontroller is established precisely for those applications where a PC cannot be used, either because the result would be a very expensive or large and heavy, or inadequate, or any other logical reason. Microcontrollers are complete computers and optimized for use in systems where other computers are not appropriate. You can control your rc model properly!

Although in embedded systems with memory Von Neumann architecture is segregated, and there are differences from the traditional definition of this architecture, the bus to access both types of memory are the same, leaving only processor bus data, address, and control. In conclusion, the rc helicopters architecture has not been altered, because the way that connects memory to the processor follows the same principle as defined in the basic architecture.