Swimming Pool Problems and Corrective Measures

One of the worst things about owning a swimming pool is looking out your back window of your home and seeing that the pool water is a nasty shade of green. Now what? The family is ready to go swimming but the pool is a mess. The fix to your green pool may be as simple as some of the following suggestions.

- No free available chlorine. Use your test kit to check the chlorine and pH levels. Remember to make sure that the test kit reagents are not out of date and or the test strips are still current. Add chemicals as needed.

- Poor water circulation. Check the filter is it dirty. If you have a cartridge filter is the cartridge worn out? If you have a DE filter is it time to backwash or completely tear down the filter, check the grids and re-charge the system with clean filter powder. If your system has a sand filter it might be time to empty the sand and recharge the filter.

- Check the pump basket. If the basket full? Check to make sure that the basket is in good condition. A cracked or broken basket can allow items to bypass into the pump impeller, causing pump failure.

- Lack of proper swimming pool maintenance,which includes periodic super-chlorination and fresh water replacement. Remember to brush your swimming pool surface on a regular basis.

- Check the level of Cyanuric Acid (Also known as CYA, Stabilizer and Conditioner) in the pool water. Levels over 80ppm can cause the water to "Cloud Up". The best way to lower Cyanuric Acid levels is to drain some of the pool water and re-fill with fresh water. Remember after doing this to check ALL your chemistry levels and readjust as needed. (If you are using Tri-Chlor tablets to sanitize your pool water, check your CYA levels frequently. Most "Tri-Chlor" tablets will contain levels of stabilizer or CYA.)

Possibly the pool water is not green but just cloudy; here are some suggestions for this type of water problem.

- Algae in the water - Check your pool chemistry and adjust as needed

- Too high a hardness level - Use your test kit to monitor. If the harness is too high some dilution might be needed.

- Too much backwashing of the filter. Backwashing causes pool water to be flushed out of the pool, remember after major backwashing and addition of fresh water to the pool to check your pool chemistry.

- Plugged or channeled filter. Clean your pool filter, replace the filter media if necessary.

- Improper pH - Adjust your pH to the recommended levels.

- Improper total alkalinity levels - Adjust as needed.

- High total dissolved solids content in the water. If the total dissolved solids content in your pool water is to high some dilution might be needed.

Owning a swimming pool does not need to be a time consuming, pain in the neck chore. With the correct equipment installed (pump, filter, automatic cleaner, chemical feeder, valves) and a good test kit, keeping your swimming pool water crystal clear and ready for swimming is easy and fun.