The great world of rc cars

Many claim that rc cars are impeccable systems. The only flaw of this system is the greater weight of the screws (try to choose the smallest possible), a 2.5 mm in diameter and 15 mm long weighing 0.30 gr. The brass is lighter. Although it does not tend to sag when it becomes necessary to disassemble the rc cars whole, should replace it before you put a drop of diluted cement in the stabilizer, move a wire to distribute it inside and let dry before replacing the screw.

Take special care not to force the screw tightening deform the threaded hole for the review and not enough cement to reconstitute. This system is not advisable to remove all routinely for transport, in this case, protects the stabilizer and rudder with a covering of mulch material.

I have this restraint on my rc cars A-Box ½ A, which is characterized by its stabilizer good size. Once I threw it with the receiver off but the only damage was a release of the F1, despite being dismantled before the set a couple of times. A very easy way to install the fuel load line is by making a hole about 1 mm greater than the diameter of the hose into the side of the fuse, is passed through the hole and then cover with aluminum rivet.

At the end of fueling the cap (rivet) the hose is pushed in and it being swollen by the cap is attached to the side, and from the outside will look just the head of the plug. It also overflows. You can use these vents and so on.

It must be provisioned with a CO2 extinguisher, essential, a bottle of propane-butane gas with shutoff rc cars valve and the bottle of kerosene with electric pump two liters hand transfer take work. The gas bottle valve, despite of being a single element, may give some problems. Do not forget that this accessory is a small welder sold in hardware stores to which the nozzle is removed and placed half the fuel filter, best to look at the photos, also sold in specialty stores for twice the price, but that for a turbine owner does not matter.

Remember about the main rotor. It is perpendicular to this, and under these conditions the rc cars move offset by their own weight, however. Get to know wonderful tips and hints. You will be surprised on the much functionality.