Air Conditioning Installation in Gilbert AZ – A Guide
When undergoing an air conditioning installation in Gilbert AZ, the location of the condensing unit is of huge importance as it is the device that essentially keeps the insides of the walls cooler in comparison to the outsides. Wires of necessary thickness must be chosen to avoid mishaps.
Air conditioning installation in Gilbert AZ must be done to ensure the safety of the equipment as well as yourself. Follow the manufacturer’s installation manual to the word. Do not try to handle high voltage wirings,
refrigerants, sheet metal and other potentially harmful components without experience and adequate technical expertise.
Essential requirements
What you need while performing an air conditioning installation in Gilbert AZ are tools like drills, wire cutters, shears, screw drivers, etc. which are available in your toolkit. There will also be a requirement of supplies and equipments like condensing units, copper fittings, connectors, conducting wires, etc. So make sure all these materials are available beforehand.
Location
The condensing unit of the air conditioner must be placed on a ground level which is at least 10 – 12 inches away from the walls of the house. It must be in a location that provides adequate air flow, is near a circuit panel and provides proper drainage to avoid water logging due to rain. When undergoing an air conditioning installation in Gilbert AZ, the location of the condensing unit is of huge importance as it is the device that essentially keeps the insides of the walls cooler in comparison to the outsides.
Connections and Installations
The condensing unit, once installed, needs to be connected to the evaporator coil which lies near the ceiling. This is done by using a line set. Now, the air conditioner requires a 220 V supply to function. That is why the condensing unit must be near the circuit board. Wires of necessary thickness must be chosen to avoid mishaps.
Finishing touches
In the process of air conditioning installation in Gilbert AZ, after you have made all the necessary connections and followed the manufacturer’s guidelines, there are some essential steps which need be taken to complete the installation. The drain tubing must be connected to the evaporator coil to drain out all the water that condenses on the coil. Check that there is no room for the refrigerant to leak out of. Also, check for any unreliable connection. Finally, call an experienced contractor to solder your line connections, create a vacuum on the refrigerant line, input the refrigerant into the system at the required pressure, double check the high voltage copper wiring and other vital connections & perform a complete inspection of the whole job. If the above guidelines are followed religiously, air conditioning installation in Gilbert AZ could be done just about by anyone.
