Fixing any rc car part

Are you trying to tight or fix a specific rc car part? Get the top screwdriver and get going. Once you are done, you will notice it is a piece of cake. It is easy, so no need to worry anymore, because this too can be done in the field, and you will not be without that little screw fly, no? On this occasion, we present below an easy, fast and secure for the manufacture of leading edge with a superb finish.

Powerful tool

Creating a tool for your rc car is not impossible. It is important to clarify that the making of the tool we present is very simple, but the final product only serves to build edges only to the profile used in the model they are building. Once we have the package of ribs cut and polished, we proceed to perform a "mini" leading edge that is only the length of the packet of ribs, that is to be an edge of about 5 or 6 cm., more or less. This "mini" Leading edge, we can build it with what we please, it will be the mold of our tool (may be polystyrene, Balsa, putty, etc.).

Once you have it ready, proceed to fill with sand paper, this Mini BA even a little deeper into the package of ribs (in my case use No. 240), always keep in mind that the abrasive is facing the wood to be replaced in the belt pack to isolate. Today, the ribs are very fashionable, you can opt for the very small models (electric) or very large models, the so-called "giants".  It is advisable to settle for the elevator a couple of servos, which simultaneously make the drive or rc car traction necessary for movement of this unit.

The drawing shows how to put both servos on a "T", which in turn is sheathed in a piece to transpose the frame of the aircraft, then in his back he carries out the corresponding coupling: either to place the insurance officiate, or the traditional hook with thread and epoxy on a metal rod that will make the required movement.

Get to know how to make the hole perfectly centered on each piece. If you have to change or add one of these machines, you might as well ask for help. This must be very well done with precise adjustments. The machine has a platform with two slots. Once the block is well adjusted to the rc car base displacement, position it at the correct height and don’t touch it again.