General radio control cars approach

If you want to repair your radio control cars, consider glue for foam - The most popular universal glue of its kind will do! Since a few years ago we could not find other than that. It is characterized by being transparent and very strong odor. Diluted in acetone, and not surprisingly, eating away the foam. Houses usually sold in bottles op unbranded generics. Learn how to repair rc models.

It is mainly used for gluing balsa wood raft. Its adherent is very good, but has a defect stiffness, being so high, it is likely to break (which is not about white tail for example, which is more flexible). A technique for using them, is to saturate the wood sides with the adhesive paste, since it absorbs a lot, then put plenty be n repeat few time.

Within this classification there are two types of adhesives, white glues and contact adhesives. The first type is also called wood glue, or glue vinyl, is very cheap and well known in our hobby. The white tail is excellent for bonding balsa wood as being quite liquid, seeping into the fibers, guaranteeing a perfect marriage after drying.

Wood glue is applied with stiff bristle brush or spatula, applicable in both parts to be joined. It has a drying time of 2 to 12 hours; depending on the type of glue that is (there are different rates of drying). It is widely used in the construction of wings made of ribs, but weighs more than cyanoacrylate (which we shall see below) which is also used for such tasks, the white-tailed offers superior strength, leaving all more robust structure. This type of glue is not recommended for radio control cars parts that demand much effort as flame frames, engine mounts, landing gear, etc.

The technique most used for the utilization of wood glue is sticking with pins the rods to the desk. Contact cement will be useful- the second type of contact have queues, among which perhaps the best known is the Supergen or Poxiran. They are used mainly for bonding large areas of wood, leather, textile, etc. The application form is as follows: apply a thin layer on each surface to be bonded (i.e., both), and allowed to set between 5 and 10 minutes. After this time, applying pressure support radio control cars surfaces, and ready. The bonding is almost instantaneous, and does not lead to correction.