Seamless self-cutting step

May 13
11:36

2015

Henary Lee

Henary Lee

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

Tractrix plasma cutting machine to produce smoother than a circular saw or cut off saws. But you must be careful to hold hands to keep straight cut.

mediaimage

When it comes to cutting stainless steel seamless steel pipe,Seamless self-cutting step Articles there are several different ways to do this. Several different approaches are a bit more difficult than others, but it will also depend on the thickness of the steel sheet. In most cases, a lot of stainless steel plate and pipe fittings, you can use a simple power tools, such as a circular saw cutting. However, the 1/4 inch to 1 1/2 inches of the plate, will require more expensive cutting tools, such as plasma cutting machine for cutting. Here are the steps involved in the cutting of stainless steel.

Step 1: Set up the workspaceMetal cutting requires you to have a stable work area. This place takes away from flammable materials. Because when you are cutting metal, sparks will splash in the room. Keep those sparks away items, will effectively maintain security for you and your people around.

Step 2: Circular sawsWe most often use a circular saw to cut wood, but a circular saw can also be used in a variety of situations. For thin stainless steel plate and stainless steel pipe, saw can cut through by using the right type of blade. Installation of metal cutting blade, designed for cutting more pieces of steel. The cut is made strong backing piece of plywood board and markers. Slowly cut into the metal and keep the blades moving. You can use the grinder to cut polished, and remove any metal slivers.

Step 3: Hand sawsA small hand-held tool called cut sawing pieces of stainless steel tube through the thinner will do the trick. Many people prefer to use pneumatic cutting instruments, because the air pressures through increased power. When using the saw to work, it is important to use a full-face mask, because metal debris flying everywhere will be. You have to gradually adapt to the metal used to make the cutting blade slowly lowered to the mark. Steel slowly cut, but does not stop tool. Use grinder to remove burrs in order to smooth the edges.

Step 4: Plasma Cutting MachineWhen it comes to cutting of stainless steel material, there is a thriving tool. Plasma cutting machines use a lot safer intense beam of energy than the previous cut quite thick stainless steel. When the material is placed in a stable cutting surface, in the work area of the negative part of the cable clamp. Place the cut end of the steel surface with a difference of about 3 inches, start the cutter. It will burn through steel contacts and allows you to cut along the mark.