Copper Rain Gutters are Beautiful and Easy to Install

All around the world people are paying big money to have a professionals install their new copper rain gutters. This is fine if you have the extra money to spend, but if you do not there is no need to despair; you can install your very own gutters. It seems like a big challenge to some people and easy for others, however if you follow the right steps it will be a breeze. All it takes is a few hours, a little bit of effort and a tiny amount of tools to put in your very own copper rain gutters. The first step of installing copper rain gutters is not even installation, it is measuring, and it must be done correctly. All good construction starts with quality measurements, after all, if you take bad measurements in the beginning how can you expect the final product to come out right? You will have to determine the eave slope, which will be one-quarter inch per ten feet of installed gutter. If you choose to use less you will not have properly draining gutters in a downpour. The best way to mark this line is with chalk or some other easy to remove material. Cutting the section is the next step in installing your gutters. There are a number of tools that you can use to cut the material but snips are the cheapest and easiest. No matter what cutting tool you use, ensure that the cuts are straight. Uneven cuts can lead to a number of issues in the future. Cutting a straight line is very hard to do free hand, but if you use the correct tool for the job it is snap. A few dollars at the hardware store will get you a square, which will give you a perfectly straight and perfectly square cut every time. You wanted to know how to install your gutters and here it is. Attach your rain gutters to the structure using gutter hangers. While still on the ground, attach the hangers to the gutter no more than twenty-four inches apart and six inches from the end. If you put them further away then your gutter will have difficulty holding the weight of the rainwater. One section at a time, bring the gutters up to where they belong and attach them to the fascia with strong enough screws to support the weight of the gutter plus the water it will hold. The last thing to do is to add the downspouts in the proper locations. Put the spouts in an area that allows them to drain without making a mess of any paths or driveways. As you can see, a great do it yourself alternative is to put in your very own copper rain gutters. It may seem like a daunting task at first, but once you sit down and plan the procedure out you will see that it is fun and rewarding.