Avoid engine radio control car problems

Dec 27
10:04

2011

Tae Yeon Kim

Tae Yeon Kim

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

Whenever you note something strange on the radio control car gas or car engine, you need to work on it.

mediaimage

There are many solutions to deal with gas or engine radio control car problems. For engine break we can mount a simple bench. From the figure you can get idea how to do it,Avoid engine radio control car problems Articles is simply a piece of board to which nylon screw a dimension of our engine.

The engine will set the bench (you can use the bed of our aircraft and then reassembled to the same) and all wood, engine bench and attach it to a vice that can be set on a stool in order to make shooting abroad.  

Bench shooting

For the filming is recommended to use a larger radio control car propeller and pitch. This will result in a lower rotational speed is decreasing friction. We also say that the carburetor hook a wire to go through a very small hole in the table on the back of it.

To begin with the shooting filled the fuel tank is on the back of the wood to a height such that the top of the deposit are 1 cm above the upper needle. Connect the igniter to the spark plug, then with a stick and never turn the finger pulse propeller until the engine starts.

Engine mount bolted to a table

We may also use a starter for that purpose for which we will have a cone mounted on the engine. You must know that if you're going to start the radio control car engine by hand the propeller must be positioned so that when turning the engine compression makes it is vertical to facilitate easy on. If you are flying with a landing gear model without the propeller will be horizontal to turn off the engine when landing, it is horizontal and does not break upon landing. Well, we have our motor running; we will use two reservoirs for this first phase:

-         What we will do is go accelerating torque motor and high opening the needle so that it tends to run about idling. We will do until the carburetor air inlet is open completely (full throttle) and the needle valve open so that this rotate slowly without shutting down.

-         In this situation the air-fuel mixture is rich and the engine spits out a lot of fuel and oil unburned exhaust from the motor symptoms works very lubricated and cooled.

Right now if we touch the radio control car engine it will be mild. We do so two tanks.