Making Your Towbar Last!

Though we have covered the routine inspections that must occur throughout the life of your towbar, it is important to address some simple maintenance practices that can extend the life of your Brisbane towbars.  There are plenty of parts that wear down or break along the way, but if you are able to identify these parts early on, you can save the rest of the equipment and only replace the smaller, less expensive parts.  If your goal is to extend the life of your towing apparatus, then the following information will likely pique your interest.   The following concepts will help you get the most from your investment and ensure that that don’t end up with a surprising “break” just before you set out on your next highway excursion.Protective CoveringsIt should go without saying that one must always cover their setup when it is sitting for long periods of time, but we are going to mention it here anyway.  However, this isn’t the primary “protective covering” that we are considering here.  Instead, we are referring to the rubber casings that are often used to protect the inside legs of your tow bar. After thousands of miles on the road, the rubber will often be dirty, sticky, or worn out.  If it’s worn out, then a replacement is likely in order, but if you find that the legs are not moving quite as easily as they used to, it’s probably because the grime has built up to a point that a deep cleaning is required.  You can wipe down the rubber surface and apply some lubrication before reinstalling the casings.  This will lengthen the life of the part, while making it much easier to slide the legs up and down.If the legs on your towing trailer are not encased with some protective shielding, you’ll want to be diligent to ensure that rusting or grime is properly controlled.  You don’t want to lose the use of such an important element, so use WD-40 (or similar lubricants) to reduce rusting.Always Checking BoltsOne of the easiest ways to significantly lengthen the life span of your towbar involves the bolts that attach the rig to your tow vehicle.  Loose bolts are easily remedied, and you can take a wrench and check all of them before putting the setup to use.  This is a great habit to get into, as it not only helps to extend the life expectancy of the towbar itself, but also ensures safety when you are setting out on a long trip.  When bolts are loose, the attached parts will vibrate, causing friction and wear that can put unnecessary stress on the steel.Proper care and maintenance is always important when you consider the stress that is placed on your towing rig.  If you’ve been searching for Brisbane towbars, then you obviously intend on using your equipment.  But, you can further extend the life of your investment by taking proper care of the towbar itself and taking stock of any moving parts that seem to be stiffening.  By regularly checking the security of attaching bolts and lubricating any sliding legs, your towbar will be one of the longer lasting elements in your recreational travels.  It is easy to focus on the cleaning of your RV, towed vehicle, or trailer, yet neglect the towing equipment that is holding everything together.  When you fire up the hose to clean everything after a trip, take a few moments to run your routine maintenance check on the tow bar . The few moments can save you quite a bit of money in the long run.