What is the Brother Printer Error Code 30?

Brother printer error code 30 is a technical error code that is encountered by the Brother printer users. Due to this error, the printer gets slow. The work process becomes slow and users find it difficult to perform a print job. This fault could be caused by different reasons. In this article, we will be telling you the top easy solutions to solve it. There are several causes behind this error. In the below section we discuss its causes and solutions. We will try to provide one of the best solutions to remove this error as soon as possible. If you are unable to solve this error on your own then you will be able to contact the experts at any time around the clock. If the problem persists after applying the troubleshooting tricks then you can easily contact the experts at Brother printer support. They easily remove your problem and gives you a 100% accurate result that is better than your expectations.

Causes Behind Brother printer error 30

There are many reasons for this error code. To remove this issue you will need to know the actual causes behind this error. Some of the causes are listed below:

• This fault occurs due to the print head cartridge fails that comes back to its home position to the far right of the unit.
• The error also occurs if the mechanisms on every side of the carriage are out of place.
• Sometimes the error occurs due to the cartridge covers that are not locked in a proper way in a place.

Solutions to Remove Brother Printer Error Code 30

To overcome this situation you need troubleshooting methods that solve your entire issues in a secure way. For your help, we provide troubleshooting tricks that are mentioned here:

Step 1.

• First of all, look at the left and right side of the machine to open the cover of the scanner by utilizing plastic tabs.
• Shift the print head to the middle side.
• Then, make sure that there is no piece of staple, paper or any paper clip.

Now check the fault still persist or not. If yes, then move to the next step.

Step 2.

If the above step fails to solve this error then you can follow these steps to solve your problem.

• Hold the scanner cover by using the plastic tabs of the cover until it locks accurately into the open position.
• Make sure that you have clean all the encoder strip, easily slide the print head over the right side under the printer cover.
• To clean the encoder strip, use a lint-free cloth, grab the strip on both sides firmly and scrub the wipe from one end to the strip to another at least three times.

If the error still persists then you don’t need to get worried. The experts are always with you to solve your entire issues in a secure way without any difficulty. They will guide you to solve this error. To get the instant help dial Brother printer tech support number +(1)-833-781-7339.