Atomized metal powder in soft magnetic area

Jun 14
11:00

2012

David Yvon

David Yvon

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

With continuously improvement in the performance of electronic equipment in recent years, malfunction and mutual interference between the components are caused by unwanted electromagnetic wave (noise) in the machine.

mediaimage

So there is an increasing emphasis on measures to prevent electromagnetic interference. An effective measure is to use the electromagnetic wave absorbing materials. The electromagnetic wave absorbing rubber board DPR is successful developed now. It is the dual-phase rubber in use of metal powder technology. Its absorption principle is to transform the electromagnetic waves into the form of heat by the soft magnetic metal magnetic losses or eddy current loss.

Used as a soft magnetic metal powder processing and corrosion resistance,Atomized metal powder in soft magnetic area Articles flame resistance is very good soft magnetic stainless steel powder, through processed into the shape of the foil aspect ratio to increase and anti-magnetic coefficient is small it has a very high magnetic conductivity. DPR is the foil sheet stainless steel powder dispersed in the composite electrical insulating rubber, the high frequencies above 1GHz better than ferrite electromagnetic wave absorption characteristics can change powder types, shapes, filling volume and product thickness to control its absorption characteristics.

The pressure of the powder magnetic core is made of molding the soft magnetic copper powder (FCu) and a mixture of insulating materials used for the power of the machine chokes like device. Usually the dust core is mostly made of Fe-Si-Al alloy or Mo permalloy single ingredient, but in recent years can not meet the diversified needs on the core. Therefore, the newly developed core powder is mixed with two or more different components of the soft magnetic alloy powder and an insulating layer coated on the surface of the alloy powder cores with powder. This core of powder soft magnetic alloy powder by adjusting the mixing ratio, powder size distribution, stamping and heat treatment optimization. It can control its magnetic properties in many aspects.

There are two classes of powders for magnetic core. One of them is the core chokes material for switching power supply and other power supply. It is suitable for high frequency range from tens of kHz to hundreds of kHz. The other on is suitable for frequency in a few of kHz. In particular, it requires for the use of high magnetic flux density, such as high-speed motor core and electromagnetic valve core for automotive electronic fuel injection equipments.Source:http://www.mhcmp.com