RC helicopters – setup and assembly guidelines

Jan 13




  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

There are several important things that should be observed before flying RC helicopters.


I must tell you that assembling RC helicopters is not an easy job as it requires a lot of effort and technological awareness. If you have a little bit knowledge about scientific approaches then you can start assembling a radio controlled helicopter without any worries. Before start assembling RC helicopters,RC helicopters – setup and assembly guidelines Articles always make sure that you have all tools that you need including needle nose pliers, hex drivers, thread lock, screw drivers, ball link pliers and super glue. You may need to get some other important tools for the better assembling. However, it is sensible to make a list of tools that you require for this procedure. After making a list of apparatus, you can go to the market to purchase them. It is also very important to organize everything. Lay down each and everything on a towel or table cloth to systematize. In this way, you will not have to find anything from different corners of workplace.

Take all the important measurements using the digital calipers. Make sure that you have measured the correct length. Swash plate must be leveled. In order to check the level of a swash plate you can use a leveling tool. Protect the frequency crystal of RC helicopters using the electrical tape. Make sure that is properly fixed because if it falls out during the flight then it may be your last flying experience. Therefore, you must pay proper attention on securing the crystal of helicopter. If you are having a small glow starter do not overlook to take it off subsequent to starting your engine. Tying a string to it can be visual cue to remember.  If there is any metal part that is not good to fit then you can use a pencil torch or soldering iron. The most important thing is to tighten all the bolts of RC helicopters because a single loose bolt can bring a disastrous situation. You should check all the bolts with great care if you do not want to ruin your expensive radio controlled helicopter.

You should remember that RC helicopters are not inexpensive toys that do not require any care and maintenance. Most of the models of radio controlled helicopters are very precious and they need best protection. Availability of all the important tools helps you to keep the RC helicopters in a well working condition. Hence, assembling procedure of a radio controlled helicopter cannot be performed without proper apparatus and skills.