Creating rc helicopters to learn how they work

When it comes to creating rc helicopters, instructions are not so hard. The holes for placing the bar will be the same diameter as the threaded rod that we use. The map size can help you follow steps properly.

You will need to:

1. Cut out the pieces

To this end, the pieces are drawn on the plywood while the measures taken, and then with a jigsaw or hacksaw with Cut out the pieces. Power cut holes in the panel and the drawer, and drill the rc helicopters vent piece. Once cut the pieces, we will review them with sandpaper (sanding block) to remove impurities. When sanding the hole in the drawer, be careful not to go through the sand, would be ugly, it's better to go slowly and keep trying until it fits snugly, but without touching. Now it should make the parts in pencil, showing where each piece goes, not wrong.

2. Box assembly

If we have mounting brackets, we will use them if we do not; we will use a table that is well cut square. We help seal adhesive for attaching the set are going to hit. It is interesting to start from the drawer, and when will adjust the gap where fitted, will guide us. Once dry, sanitize for burrs. Do not skimp with white glue when gluing the pieces.

3. Assembly of other parts of the rc helicopters box

This will position the upper part of the drawer on the front. When the glue dry and pasting continue placing the rest of the pieces, following this order: glue the inside edges, base and finally the rear. Then paint the entire assembly before placing lids panel and battery power that is open now and also painted these two pieces. After placing the bar / handle of the box with fastening parts of the aircraft.

Consider Clamping forks at each rc helicopters which makes them to your liking and thinking of his model aircraft. If you do not see them spinning, check that the twist does not touch the front and back. It's a different way of saying prehistory. As some of us were born before the magazine is meant as modelers cannot help taking a look back at what was the model helicopter when we started, as children of witnessing only anecdotally proportional radio control the operation of a radio pulse of these that continually bent the rudder from side to another, but nevertheless it is a miracle technique allowed a controlled rc helicopters flight.