Benefits of the Design for the Application of the Regenerative Turbine Pump

Dec 13
08:38

2012

Bob B. Hamilton

Bob B. Hamilton

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

Regenerative turbine pumps are sturdy workers and you can mount them in many different locations. The pump materials are stainless steel, iron or brass. They may be flex-coupled or close models. Read on to learn more about this topic.

mediaimage
The sizing of regenerative turbine pumps is for approximately 20 percent of the flow of the total system. While this makes them particularly good for oil recovery systems,Benefits of the Design for the Application of the Regenerative Turbine Pump Articles it also makes them a viable choice for wastewater treatment for specific situations. High strength wastewater that comes from pulp and paper manufacturing, the food and beverage industry, breweries and petroleum industry can present its own special problems solved by the regenerative turbine pump.

Regenerative turbine pumps are sturdy workers and you can mount them in many different locations. The pump materials are stainless steel, iron or brass. They may be flex-coupled or close models. There are numerous capacities from five to over 120 GPM. You can select pumps with heads in excess of 200 feet, too. Regenerative turbine pumps also have economical seals.

You’ll find these pumps come in both dual-impeller and single-impeller units. It contains an internal cavity that offers both maximum pressure and capacity and at the same time minimizes the horsepower required. The design of the pump optimizes the fluid pumping dynamics and that improves overall pressure and efficiency. When in the pump cycle, there’s almost a complete dissolution of the entrained gasses and it’s at the highest possible volume. This minimizes the horsepower used since it only requires a single pass.

The pump has a high efficiency range and produces bubbles approximately 20 to 30 microns in size. In most cases, they’re termed whitewater. Whitewater technicians need to select carefully the pump and materials used for piping by the type of fluid and temperatures expected. They should also be able to control safety features, as well as having built in automatic features.

Saturation time needs maximization too.
If choosing a pump, you also need to match the hydraulic capacity and system flow and consider the regenerative turbine pump limitations. These include a discharge pressure of 125 psi with a seal pressure of 200 psi. Suction vacuum is 26 inches of Hg with a flex speed of 1,750 rpm and a close speed of 3,450 rpm. Its temperature can be between -20 degrees Fahrenheit and 150 degrees Fahrenheit.