Right Way of Pouring of Concrete Floor

May 10
12:16

2012

Ma. Theresa Galan

Ma. Theresa Galan

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

Pouring concrete yourself is a difficult job but can save you some pennies if you're willing to brave new territory and give it a try. If you decide you would like to undertake such a big task, you can rent materials rather than buy them, which will save you some headaches

mediaimage
Although it is not difficult to learn how to pour concrete,Right Way of Pouring of Concrete Floor Articles make sure to thoroughly read through all instructions. Concrete floors are major component of many buildings, from homes and garages to shops and sheds. Pouring a concrete floor is hard work, and it takes skill, strength and tools. You may wish to have this job done by a pro, but you can do it yourself. The tools can be rented at many rental places, and the skills are not very difficult to learn.

The first thing you want to do is determine what type of concrete you will be using. If your job is going to be relatively small, you would probably want to use ready mix concrete, which only requires the addition of water. On the flipside, if you have a much bigger task at hand, you might consider transit mix concrete. This involves a barrel truck from which to lay down the concrete and is the easiest way to perform larger concrete setting jobs. Keep in mind, however, that there will be a fee for delivery and pre-mixing of the cement.

Before the cement is to be poured, you will need to create a form, which is a requirement for the majority of concrete jobs. Some of these are above ground while others require some digging underground. Dig to the desired level and create the shape and size needed for the form. Temporary posts should be placed within to establish the slope of the concrete, and for the final step, nail stakes along the form.

When the forms are set, spray them with a garden hose to lightly moisten them. Then, you can fill them with cement in preparation of pouring. Be sure to mash down all the cement with a tamper to make it compact. Or, you can even put on a pair of rubber boots and tread on the cement.

Pour the concrete where you want it, filling the area bit by bit. Use a 2x4 to tamp it down to make it more compact after you lay it down. A magnesium concrete rake is also useful for getting hard to reach areas due to its extension handle.

Once the concrete has set for a sufficient amount of time, use a 2x8 plank to create contraction joints. The joints are necessary because they allow concrete to expand and contract in extreme temperatures.

Keep in mind that you should always check your state and local codes before the start of your project.

More helpful topics in the links below:

carpet laying, carpet layer auckland, laying carpet

Article "tagged" as:

Categories: